18-24 months durability
Easy to apply
Adds gloss, water and dirt repellency

30ml will coat a small car. ( Ford Fiesta, BMW 1 Series, VW Polo )

50ml will coat a mid - large car ( Ford Mondeo, BMW 5 Series, VW Passat )

Why Use Gtechniq EXO?

EXOv4 delivers a hard film that makes water-spots easy to remove, offers great resistance to all wash chemicals and can help withstand micro-marring. It produces a high-gloss, warm-looking, extreme hydrophobic finish.

It has a consistent film that is more durable and resistant to road salt and washes chemicals than its predecessors. Application is easy, with a slow flash-off time, giving more time to achieve a perfect finish.

All of the above combined with the introduction of a good degree of swirl resistance means EXOv4 represents a major leap forward in Last Surface Protection (LSP) technology.

Simple Steps To Help You Get The Best Results

EXOv4 can be applied as a standalone coating or as a top layer for Gtechniq C1 Crystal Lacquer or Gtechniq Crystal Serum Light (CSL) – we recommend applying C1 or CSL as a base coat for easy to mark and dark paints
If you are applying over C1, EXOv4 should be applied a minimum of 4 hours, but less than 12 hours, after you finish the C1 application
If you are applying over CSL, EXOv4 should be applied at least 1 hour after application of the CSL.
Ensure that your vehicle is out of direct sunlight but warmer than 5 degrees celsius, is completely dry and will stay dry for at least 12 hours after application
Wipe down all surfaces using Gtechniq Panel Wipe and a Gtechniq MF1 ZeroR Microfibre Buff Cloth (apply the Panel Wipe directly to the cloth and not directly to the panel) – if you are applying over newly applied C1 or CSL, this step is not required
Shake the bottle well and wear gloves
Prime the AP2 Ultra Soft Foam Filled Applicator evenly with a good amount of product so that the pad is saturated
Apply with the applicator provided in overlapping strokes to an area roughly 2ft by 2ft (60cm x 60cm). Wait for 1 to 2 minutes after applying to a panel and buff with an MF1, followed by a second MF1 to remove any smearing, leaving the surface slick
Once you have finished coating your vehicle we recommend repeating the process starting from the same place as you did for the first layer and coating panels in the same order so that you coat your entire vehicle with two layers of EXO
Allow the coating to cure for at least 12 hours before exposure to moisture
After application, we recommend that you do not wash the car for at least 7 days
Store in a cool, dry place
If opened, use within 3 months, if unopened, use within 12 months
EXO safety sheet

All Products

SP2 GSpray Bottle

MF4 Drying Towel

QD Quick Detailer ( 250ml, 500ml, 1L & 5L )

G4 Nanotech Glass Polish 100ml

HALOv2 Flexible Film Coating ( 30ml & 50ml )

C5 Wheel Armour ( 15ml & 30ml )

L1 Leather Guard AB ( 100ml & 500ml )

EXOv4 Ultra Durable Hydrophobic Coating ( 30ml )

T1v2 Durable Tyre Gel ( 250ml, 500ml & 1L )

C6 Matte Dash AB 100ml

G6 Perfect Glass Cleaner ( 500ml & 5L )

MF1 ZeroR Microfibre Buff Cloth 10 Pack